OKE machinery's taper bushing

Installation:

1.Clean shaft,bore of bushing,outside of bushing and hub bore of all oil,paint and dirt. File away burrs.

2.Insert bushing into hub.Match the hole pattern,non-threaded half holes with threaded half holes (each complete hole will be threaded on one side only).

3."LIGHTLY" oil setscrews and thread into those half-threaded holes indicated by on above diagram.

Caution: Do not lubricate the bushing taper,bushing bore, hub taper or the shaft.Doing so could result in breakage of the product.

4.Position assembly onto shaft allowing for the small axial movement which will occur during lightening procedure.

5.Alternately torque setscrews to recommended torque setting in chart below.

Caution:Do not use worn hex key wrenches. Doing so may result in a loose assembly or may damage screws.

6.To increase gripping force,lightly hammer face of bushing using drift or sleeve.(Do not hit bushing directly with hammer.)

7.Re-torque screws after hammering.

Caution: Where bushing is used with lubricated products such as pulley,sheaves,sprocket,gear or couplings be sure to seal all pathways ( where lubrication could leak)

8.Recheack screw torques after initial run-in, and periodically thereafter.Repeat steps 5,6 and 7 if loose.

Removing:

1.Remove all screws.

2.Insert screws in holes indicated by  on drawing.Loosen bushing by alternately tightening screws.

Application:

Mount these taper lock bush flush into pulley,sheave,sprocket,coupling